• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
13 Results Found for Dry Kiln Viewing 1 - 13 of 13 results
PREMIUM LISTINGS
SII Pallet / Firewood Kiln. Holds approximately 600 pallets / 14 Cords Firewood. Kiln Size: 26’ Wide x 24’ Deep and 9’ Floor Door Height. 6’ x 20’ Controller Room. SII 7000 Control System. Kiln Fan Props has 36” 6-Blade Alum Rev w/P1 - 1 3/8” Bushing. Fan Motors 3hp TECO Class- H 1200rpm TEAO. Heating System has Eclipse ImmersoJet Burners. 2 Million BTU (propane). Spray Supply is Dema Solenoid Valve 401P, 120V. Humidification System Nozzles PJ15 1/8”MPT Fog Nozzle/Bete. Vent Actuators are Duradrive MF41-6343 Actuator. Door Carriers are Manual.
Equipment Location:Candler, NC
Blue Ridge Rugged Timbers
336-466-5044
STANDARD LISTINGS
AMERICAN WOOD DRYER KILN - 2 chamber package type dry kiln. New 1994. Very good condition. Requires low pressure steam (15 psi). 5 VFD controlled fans. Includes controls and boiler room (boiler available). Capacity approximately 50,000 board feet of 4/4 per chamber for a total of 100 MBF. Dimensions available on request.
Equipment Location:Columbus, GA
Ben Jones Machinery
706-324-2604
AMERICAN WOOD DRYER Direct-Fired Lumber Kiln - New, still at MFG' place:Now offered at 20% discount off the original cost and complete with the following main components and features: -- 20’ x 54’ in size, 39,000 Board Foot (92.03 Cu. Meters) capacity or 62,100 linear feet capacity, Package Type, Front Loading, Dry Kiln Building features: -- Gable Roof. -- R-20 Insulated ALCLAD Aluminum Panels, stainless-lined. -- Fan Deck Grating. -- Motor removal equipment. -- Drystar® Computer Control System, single head zone with (4) Rtds. -- 10 MM BTU/Hr. Natural Gas Fired Furnace. -- Kiln control and furnace Room approx. 20’ x 30’ x 11’ high on lowest side. -- (12) Steel lumber backstops. -- (7) 20 HP Air Circulation Fans. -- (7) SIEMENS Variable Frequency Fan Drives for 20 HP Fans. -- Accu Spray air atomized cold water Spray System with (7) Spray Nozzles. -- Insulated Door mounted on overhead track.The following $-figures show the distribution of funds applied to the original purchase price of nearly ...$466,000: ● Kiln with Gas Fired Furnace: ...$391,310 (The furnace itself is approx. ...$100,000.) ● Control System: ...$16,540 ● Furnace Room: ...$33,145 ● Backstops: . ... $ 5,400 ● VFD’s: ...$14,500 ● Water Spray: ...$ 5,100NOTES: ● The manufacturing of this equipment is nearly complete but halted pending the sale to allow for new Buyer to make any modifications desired. The price offered includes balance payment due upon completion unless modifications are requested by Buyer. ● The equipment is located at AMERICAN WOOD DRYER, LLC, Clackamas, Oregon. ● Installation by the manufacturer can be acquired directly from AMERICAN at Buyer’s option. ● Warranty offered by AMERICAN WOOD DRYER as part of the factory installation. ● Building shown in photo is representative only, not the one for sale here.
Equipment Location:PACIFIC NORTHWEST
Bill Christoffersen
800-374-5009 ext:365
AMERICAN WOOD DRYER KILN - 3 chamber package type dry kiln. New 2004. Very good condition. Requires low pressure steam (15 psi). 4 VFD controlled fans in each camber. Includes control room with kiln controls. Capacity approximately 25,000 board feet of 4/4 per chamber for a total of 75 MBF. Dimensions available on request.
Equipment Location:Columbus, GA
Ben Jones Machinery
706-324-2604
Dry kiln I/M 32’x35’ chamber 1993 hurst natural gas boiler 15 psi steam 30 psi water 300 sq ft heating surface S/n FB 300-15-10 Price $38’000.00 loaded
Equipment Location:Lafayette, AL
Abneyco Equipment LLC
706-590-3624
Kiln Direct Dry Kiln
Equipment Location:Clarksburg, TN
LPS Equipment & Acquisition Co.
731-986-4351

Kilntec Kiln Dry Kiln

Call for Price
Machine Number: 1750 Machine Type: Dry Kiln Manufacturer: Kilntek Model #: Dry Kiln Location: South East Kilntek Lumber Dry Kiln Call For Details
Equipment Location:Blowing Rock, NC
Carolina Used Machinery
828-773-2204
Lumber Dry Kiln with a total capacity of 122,000 board feet and the following major components and features: -- (2) KATRES AFK 61,000 BD. Ft. aluminum link chambers, 45' wide X 80' long X 26' high. -- (8) 0.5 HP Bi-directional computer controlled circulation fans. -- (2) 10 HP BECKETT blowers. -- (2) NYLE HT 108 dehumidification drying systems with (2) 40 HP compressors each. -- (1) 40 BHP BOILERSMITH oil fired boiler and BOILERSMITH receiver pump. -- These are forklift loaded kilns and price includes loading for transport. Buyer responsible for freight.These units are dissassembled and in storage.
Equipment Location:EASTERN CDN
Bill Christoffersen
800-374-5009 ext:365
NYLE 30 (Similar to the newer HT42) Dehumidification Drying System:Complete packaged Dehumidification Drying System ready for installation into custom-built drying chamber. -- Designed to operate effectively at low humidity levels. -- The Model 30 has a load design capacity of 20,000 to 60,000 board feet (depending upon species and moisture content). -- Design temperature range of 80° to 160° F. Removes more than 2 tons (4,200 Lbs) of water per 24 hours.Complete with the following features: -- Nearly New CARLYLE 30 HP Compressor with latest Refrigerant specification. -- (5) 3 HP Circulation Fans. -- 7.5 HP Internal Blower. -- PARTLOW Chart Recorder, Model MRC 7000. -- Aluminum Cabinet. -- Copper Coils. -- Still in-place in good operating condition. --NOTE: Adjusted price now includes refrigerant pump-down, machinery removal, and loading onto Buyer's truck.This is a great unit with a huge capacity the same as the newer Model HT42.
Equipment Location:ATLANTIC CDN
Bill Christoffersen
800-374-5009 ext:365
SII 100,000 Board Foot Dry Kiln With Boiler & Controls & Infeed, Steam Pipe.
Equipment Location:Clarksburg, TN
LPS Equipment & Acquisition Co.
731-986-4351

Unknown Dry Kiln

Call for Price
Dry Kiln Framing for the Building Doors Included.
Equipment Location:Clarksburg, TN
LPS Equipment & Acquisition Co.
731-986-4351

Unknown Dry Kiln

Call for Price
condensate tanks, da tanks dry kiln motors used, some are pretty new 7.5 hp $700.00 each, 10 hp $ 800.00 each ,15hp $900.00 each,20 hp $1500.00 each 25 hp $2000.00 each 40hp $ 3500.00 each, 75hp $4500.00 eac, I have baldors, Toshiba call for more information will make deal on motors for 10 or more lots of dry kiln parts and we make dry kiln parts call on information on the condensate tanks or the da tank have lots of kiln parts and also we do work on the dry kilns
Equipment Location:rathdrum, ID
sb kiln coating &maintenance
208-691-7770

Unknown 4 X 9 Dry Kiln

Call for Price
4' X 9' All Steel Kiln Carts Wheel Diameter- 8" Wheel Width- 2 1/2" 72" Between Wheels. Quite a few have the Adjustable Wheels Just need to drill new holes
Equipment Location:Clarksburg, TN
LPS Equipment & Acquisition Co.
731-986-4351