16' Cooper End Dogging Scragg 54" Blades,200HP Motors, Slab Drop each side, Deluxe Operators Cab w/ Controls, Infeed Log Deck. S/N CM6125

Morbark 640 Debarker System 3 Strand Log Infeed to Infeed Trough Debarker Head with Cab & Controls Outfeed Trough 3 Arm Kicker & Bark Conveyor.

Refurbished Precision P742H Rosserhead Debarker S/N D529 with Built in Barn Sweep and 25' Rise.

1993 Viking Turbo 505 NAILER S/N 9500086 With Pallet Stacker S/N 410-M

2019 Wood-Mizer Vertical Band Tri Scragg 15HP Electric Motors with Log Infeed Deck & Log Incline Deck TVSEC15U Set Works, Slab Removal Conveyor. Out Ready to Ship.

Left Hand Double End Trim Saw

Several C-Faced Motor & Gear Reduction Box Drives

Gas Powered Auger

Acme Carbide Saw Sharpener

Acme Carbide Saw Grinder

Acme Post Grinder

Acme 15 KVA General Purpose Transformer

9 1/2"x 8' 4 Strand Angle Transfer Deck & HYD DRV

Whirlwind 212R Pop-Up Saw w/Infeed, Outfeed & Dead Rolls

20' x 12" Vibrating Conveyor

24IN x 30FT with 8IN sides, 31FT high

10' x 12' Chip Screen

Acrowood Diamond Roll Screener S/N 5533-1 New Never Been Installed7' x 10' supplied with 20. Serial # is 5533-01. The shafts are 80mm diameter with 3mm knurl pattern making it a Particle Screen. Gaps 1-7 have an IRO (Inter-Roll Opening) of 2.0mm using 2mm shims. Gaps 8-15 have a gap of 3mm using a 2mm and 1mm shim and gaps 16-19 have a gap of 4mm using a 2mm, and two 1mm shims. This will pass small to large material as you move down the screen. It was supplied with a Falk shaft mount reducer with telemecanique zero speed switches. It requires a 7 1/2 HP , 1800 RPM motor which was not supplied. It runs at approximately 130 FPM.

ACS Quick Attach Bucket

(3) Hydraulic 5HP & (1) Electric 4' x 6' Scissor Lifts Ready to Go.