Avani Fume arm for wielding and grinding used as pictured

This machine is in good working condition and can be inspected under power. Specs (to be confirmed): - Electric spindle 18.1 HP - X-axis stroke 145.66î - Y-axis stroke 82.67î - Z-axis strke 13î - Working area 145.66î x 68.90î - Automatic tilting head - Telescoping spindle extension for surface polishing - (26) ISO 40 tool holders at rear - Bar code reader for program interface

750 kw Generator This was owned by a hospital. Seller purchased both units and never used them.

12" x 16" Flats? 15" Round?Band Wheels: 16" Diameter?Blade Size:1.5" x 162" x .035"? Work Height:30"? Blade Speeds Approx.: 40 - 450 FPM

Generac 200 HP Genset

General Thermodynamics Genset Set up for 480 volts Low Hrs., only 1,728 hrs., 275 KW, Cummins Deisel. Always started very well and ran extremely smooth.outside enclosure has easy access doors all around. Deisel tank holds enough to run genset for at least 24 hrs.+ Cummins Diesel engine

Intermac Genius 37 LS-MT Glass Cutting Line

Jet Turret Milling Machine

Table Size 10" X 44" Longitudinal Travel 24" Cross Travel 16" Vertical Knee Travel 16" Spindle Speeds (Variable) 55- 4,250 RPM Spindle Nose R - 8 Spindle Quill Travel 5" Spindle Quill Feeds (3) 0.003" - 0.0015" - 0.006" 230 volt 3-phase

Lodge & Shipley T 60" Right Angle Chucking Lathe System will need to be rigged out of current location. It is still under power for inspection.

12 Foot Bed 24” chuck 230 volt 3-phase

Motoman Robot Refurbished a few years ago. In good working condition.

Deuma RF/S150 A-V

Approx. 12” blade 2-1/2 HP motor vice for holding materials 230 volt single phase

2004 Sennebogen 835 recently refurbished

Tree 2UVR Vertical Milling Machine Incudes Elephant Vise Good Condition