Klamath For Sale

Used 8.3 Cummins electronic-runs and operates flawlessly with no visible blow by

Rebuilt Cummins 6.7 In Stock

Cummins 600KW Enclosed Generator Skid Mounted - 277/480V - 60Hz 638 Hours Digital Controls Unit has been tested

Cummins 8.3 ISC, new turbo and water pump, $5500

Curtis 7.5 HP Single Phase Compressor

72" x 60' Belt Conveyor with both an incline and a decline. Electric motor.

4' Steel Baskets 16 Available

M.A. Ward 24ft Outfeed for Edger. 53"x24'x49" high. No drive.

This line is for sale as one lot. 1. Vertical Reciprocating Conveyor (VRC) - 106x80x72 - Roller Dimensions: 94x3 inch diameter - 72" wide roller deck 2. Chain Transfer Conveyor - Space between rollers is 4 feet (size of Transfer deck) - Rollers on each side measure 94x3. - Roller housings on each side measure 72x96x26. -Total dimensions: 72x224x26. 3. Straight chain driven Conveyor - 72x100x26 - 8' rollers 4. 360° rotating turntable conveyor -Base dimensions: 74x58 -Roller dimensions: 40x3 - Conveyor Dimensions: 72x48x26 5. Straight belt driven conveyors (4 of them) - 54x12x12 belts not included 6. Curved belt driven Conveyor - Exterior curve: 224x48x26 - Rollers are 40" long and vary from 2-4.5" wide along curve. 7. Line conveyors (2) - 144x36x24 - Rollers available for this 8. Stacked rollers -96x66x75 - Roller dimensions: 80x3 9. Straight Gravity Rollers (18 of them) - 148x36x6.25 These rollers were stacked 4 high. Legs are available to stack them or they will work in line. 222' run consisting of 18 pieces. 10. 32' decline belt conveyor - This has damage. See last photo.

Custom Built Single Head Notcher Manual

Extra Heavy Duty 40' or 45' Closed Top Chip Vans, Steel Construction with Reconditioned Full Frame Chassis, New Michelin Recaps, Painted. Year Models May Vary Starting @ $20,900

Single Head Pallet Notcher - New with warranty! 7.5 HP Motor 220/440 3PH Maximum Notch Size: 9" x 2-1/2" x 1-5/8 Power switch with magnetic starter Cutterhead with 4-straight HSS knives (optional 40 knife cutterhead) Dimensions: 48" L x 36" W x 40" H

Single Head 4 blade Notcher: custom built, lightly used Motor 10 HP, 220/440V, 3 phase Maximum notcher size 9” long x 2-1/2” height x 1-5/8” depth Cutterhead with 4 straight HSS knives installed

4- Head customer built resaw 6" Wide belt Hydraulic hold down rollers 15 HP Motors on each head Pneumatic tension

6' x 8' Operators Cab

Custom Built Heavy Duty Scragg Deck C55B rooftop chain 3’-7’ legs, 33’ long, 30” wide, 24’ catwalk, hydraulic motor drive

42' Log Trough out and ready to go.

Custom Built Log Trailer 40' 2 bunk Good tires Good brakes Current valid inspection

Custom Multi Blade Gang Rip

Potential 9 saw Trimmer on Common Shaft run off 1 Electric Motor