Equipment For Sale

Baker Band Resaw BBR-O Return Conveyor

Baker model a bandsaw with return conveyor

Baker 16" Blue Streak Grade Resaw w/Cab & Setworks

BBR-0 | Electric Drives | No Hydraulics | 30 HP Motors | 1992

2018 Baker Model C 4 Head Resaw Well maintained Work ready Only selling to go to a smaller unit SN 18-4895

3650 Baker Super Streak Mills

Single head Baker resaw | 3 Phase 480V | 30HP | Capacity is roughly 6" wide x 6" tall

Baker 12" resaw w/ cross over chains and return. Machine has four sets, all manual, line shaft ready. Located in PA. #C916

Baker High Speed Deduster

Baker M4 In Line Deduster

Baker Band DBL End Trim Saw with Belt Waste Conveyor & Hyd Drive

480V | Model # BBR-0 "A" | Serial # 09-4089

The Baker M4i DeDuster has been designed to be a super-high-performance dust removal machine that will accept and remove sawdust from the highest production multi-head horizontal band resaw today. The M4i DeDuster can operate at over 700 feet per minute! Boards drop into the M4i DeDuster hopper. The hopper’s height adjustment (for the amount of lumber), indexable stops (for the length of the lumber), and adjustable fence (for the width of the lumber) allow you to set it up for the most efficient operation. This virtually eliminates jam-ups. The hopper’s variable-speed conveyor sends the lumber through the M4i DeDuster chamber one piece at a time. The rear height adjustment of the conveyor can be adjusted from a minimum of 24" and up to 34" maximum. Inside the M4i DeDuster chamber, high-speed brushes clean all four sides of the boards. The independently powered brushes are fully adjustable for longer brush life. The specially designed chamber maximizes air flow, directing the dust out the dust chamber instead of back onto the boards. The entire side of the chamber easily opens for full open accessibility. The Baker M4i DeDuster comes with its own electrical panel and a stand-mounted, remote start/stop control station.

12" Baker BBR-O Single Head. 30hp Motor. Located in IA. #C968

1995 Baker MDL BBR-O 3HD Band Resaw

Baker Furnace Inc Dry Kiln 3 phase 110V

Baker Furnace Inc Kiln 110V 3 Phase

Dry Kilns (cream), Conventional Heating System, 600,000 BTU Propane, single phase, 120V control voltage, 3 phase 208V motor voltage, open volume: 672 cubic feet, max operating temperature: 500F, owners manual included, excellent condition, 2 units available

Complete Drying System, 10.5’ x 32’ Triple Pass Drum Dryer, Wood Or Gas Dryer, 300 HP Fan & Cyclone, Excellent Condition!