Equipment For Sale

Mellott rosser head 36" debarker, electric drive on head, working condition

rll case, 18" wide x 25' long, heavy duty and in very good condition

36" chain turner, hyd drive, good condition

Mellott #6 Log Turner

Mellott Chain Log Turner

Mellott #5 Log Turner

Mellott #5 Log Turner

Mellott #5 Log Turner

Mellott # 5 Log Turner

MLS Number 13567192 Mercodor Industrial Shredder Just under 2 hours of use Shredder with base Outfeed conveyor with permanent magnet belt 2 x 20Hp 480 volt/60Hz Knives 20 mm 5 hooks Machine opening 1200 mmx 600mm Can process trim ends, sawdust and plastic Machine is still set so we may process wood or plastic for samples if required.

Mereen-Johnson 424 Gang Rip Saw 230V

Mereen Johnson 524-DC/SR4 Rip Saw (4) Shifting Saw Blades Infeed & Outfeed Decks Per MFG - Saw was ingrates into: Rip Navigator Scout Deck, Power Table, Servo Laser Stand, Sorting Printer

Mereen Johnson 424 DC/SR4 Gang Rip Saw with Automated Infeed with multiple lasers manufacturer’s specs to be confirmed 24” width capacity 3-1/2” thickness capacity 75 HP main motor 3 hp feed motor feed rete 30-245 fpm

These two rip saws were removed from service in working condition some time ago. The seller purchased them and never installed them. They have been in storage the whole time.

Mereen Johnson 431 DC

Mereen Johnson Gang Rip Saw Model 431-DC s/n MJ-5132

MEREEN-JOHNSON 424 DC GANG RIP SAW 24 inch width capacity 75 HP arbor motor- 3600 RPM direct drive 5 HP variable speed feed ( new belt ) Four ( 4 ) kick-back finger sets : ( Two ( 2 ) top in-feed, One ( 1 ) bottom in-feed, One ( 1 ) top out-feed ) A new out-board arbor bearing assembly New set of alum bars and rubber slats installed It is wired 480 volts 3 phase . The serial no. is MJ-4709 One saw sleeve and set of spacers ( 6 saw blades ) Cleaned, painted, and checked.

6' wheels with 3 reworked blades.

Mereen Johnson 424 Gang Rip Saw

Mereen-Johnson Model 441-DC Gang Rip Saw Capacity: Arbor space 41” Arbor Drive: 75 HP 3600 RPM TEFC motor Feed Drive: HP TEFC variable speed direct; 45’ to 225’ feet per minute Hold Downs & Bed Plate: Four 5” dia. Air loaded high yield idle press rolls Saw Sleeve: One 41” capacity sleeve Dust Collection: Four upper dust pick-ups: two (2) 8” dia., two(2) 4” dia., one lower 4”dia. Pick-up:(requires total 4820 CFM @ 5,000 feet per minute) Swing Arm & Tip-Up Cart: One floor mounted dual shaft swing arm and one tip-up saw sleeve set-up cart Electrical: Arranged for 3 phase, 60 cycle, 460V Cameron Automated Opti-Rip Model #34F-M1 System: Manufacture Year: (2004) Complete with length measurement Tally System 5 infeed belt and chains for feeding a Gang Rip saw up to 41” wide 16 width sensors 3 sets of pinch rolls for short stock 1 fixed & 4 movable laser lights This system feed for 4’ to 16’ max lumber length It feeds from operator right to left Wired 220V; If 440V required, a transformer will be needed