Ben Jones Machinery
Ben Jones Machinery
 706-324-2604

We are the oldest and most trusted dealer of used sawmill and wood processing machinery in the eastern United States. We buy and sell used sawmill and lumber processing machinery with an emphasis on equipment suited for small to medium production operations.

Filtering

Reset All 

thru
 Used     New
Viewing Page 1 of 1
2 Results Found
Sort By 
Ben-Jones-Machinery
 706-324-2604
Unknown Chip-N-Saw  Slab Saw
$100,000

Used Chip-N-Saw for logs up to 18" butt diameter. Includes infeed, flying cant turner, canter.

 Waverly Hall, GA
 706-324-2604

 Call
Unknown End Dogging Scragg 18FT Capacity. 52 bl  Slab Saw
$350,000

Cant Optimizer system consisting of: - Built in 1990 - 12" x 24" x 20 foot - USNR Cant Infeed positioning table - USNR Two (2) sided Model 85 canter module with eight (8) knife Key Knife heads,servo positioner and arbor motors (460/3/60) - USNR Profile module with single top and bottom drum style Key Knife profile heads per side with servo positioners and arbor motors (460/3/60) - 6 ft McDonough Twin Bandmill with slide base, servo setworks cylinder and 200 HP, 1200 RPM arbor motors (460/3/60) - Outfeed side board separator c/w center chainway, hold down rolls, cant kicker, spiral roll side board rollcase, pivoting end bumpers and drives - Operators cab and operator's console - PLC control system - Transverse Scanner c/w two (2) banks of seven (7) JoeScan heads - System hydraulic power unit

 Waverly Hall, GA
 706-324-2604

 Call
Contact Us
  • Toll Free & Canada: (800) 477-7606
  • Direct & International: (931)381-1638
  • Location: 2508 Pillow Dr. Columbia, TN 38401
Copyright © 2020 LumbermenOnline.com - All Rights Reserved