Sawmill Exchange specializes in brokerage of small mills. Thin kerf, circle, scragg and more - when you need a small mill call Sawmill Exchange FIRST!
191 Results Found
Armstrong No. 51 Barnhart Band Wheel Grinder. The No. 51 is built for single band mills and comes with a 40" bed. No. 51 Truck Weight: 300lbs (137kg) Ocean Weight: 362lbs (148kg) Cu. Ft.: 14 (.4 cu. meters)
Armstrong Saw Grinder. Model #16. Good working order. Single phase power. Cap: handles saws up to 40".
Baker Tailing Belt for Resaw or other type of system. Never installed. 6" belt x 7' long. Hydraulic drive. No motor.
2000 Baker PAQ 2. 3 phase, 460. Has complete run around, conveyor, and hydraulic power pack. Last used about 3 years ago.
Used Belsaw Circular saw mill. Need some repair work done. Also have the 3-speed manual gear box.
Call for Price
Brett Riger Portable Bolter Mill. 36” blade. Tongue set up for horses, tractor etc. Cap 3' - 8' 6" length logs.
Complete Set Up to make Staves but can also be used for grade lumber. Brewco 1600 Resaw. 10' Round Table with Hydraulic Drive - custom made. 6' round table with Hydraulic Drive. 12' x 18" wide. Conveyor with Hydraulic Drive. 8' Conveyor with Hydraulic Drive. New Swing Chop Saw. North Tec Straight Line rip saw with laser light and hydraulic drive.
Buffalo 35" dust blower, all new bearings, banded belt and new 30 HP motor. Marathon motor was bought new with about 20-30 hours.
1959 Case Forklift with big tractor wheels. Gas engine. Forks not included. Cap 4500 lbs. Mast replaced with 8000 lb mast. No photos available.
1979 Case Wheel Loader, model W14. bucket only - no forks. Recent maintenance. In working condition.
CAT D348 Power Unit - Twin turbos, after cooled, oversized s/s muffler, large 4-section radiator, rebuilt in 2011, 1174 hrs since rebuild, last run 2018, always under cover and CAT maintained. Power unit only. Not a generator.
Cat Diesel model D-330. 4 cylinder with turbo, clutch and pony start. Skid mounted. Hours unknown. Runs good. Need to sell!
Chase Circular Sawmill includes log turner, feed deck, vertical edger, and 2 blowers. Unable to demonstrate.
Cornell edger, no power but line shaft ready. Currently in use. 4 sets of blades, split strobe blades. Cap 4" x 26".
Crosby Edger. 6" x 40" capacity. 6' in feed and 8' out feed. Line shaft ready. Has power drive on top rolls on in feed.
Crosby Edger. Heavy Duty. 2 blades can be stationary or moveable. No power. Line shaft ready. Cap 6" x 40". Needs about 150 HP electric motor.