Description:

TYLER - 2400: Slat-Wall Machine -- SpecificationsProduces T-slots "Slat-Wall" for architectural/store fixture panels.48" x 97" Max. panel capacity., 24" x 24" min. cap., panel thickness 1/2" to 1-1/2". Machine capable of processing up to (40) panels/Hr; depending on material density, thickness, and the slot profile. -- Equipped with:Machine is currently setup with: (18) Router spindles on 3" centers.Spindles are driven in groups of (3) with: (6) 7-1/2 HP - 3,450 RPM Motors that drive the (18) router spindles; all router spindles rotate @ 15,400 RPM.Machine can accept up to (21) router spindles & the additional spindles can be activated by adding (1) additional 7-1/2 HP - 3,450 RPM motor. -- Machine Operating SequencePanels remain stationary on top, pneumatically clamped in place while the bottom mounted router bank traverses the full length of the panel with a high-speed return,Variable feed speed control, router assembly traverses on ground & polished rails with chain drive.Panels are positioned along the 8' rear edge fence line; distance from the panel edge to the centerline of the 1st cut can be adjusted from 0.0" - 3" (1 router spindle pitch). -- Operator & Machine ControlALLEN-BRADLEY Electrical controls for the machine cycle; "setup" mode of operation.Machine cutting cycle is initiated by: 2-Hand Operator safety buttons located on the right front of machine. -- Complete with:Overhead holddown assembly with: (2) Large air cylinders; (6) arms with spring loaded clamping pads hold the panel in place.Panels are loaded from the 8' front and exit to the side for easy unloading. -- Options Include: Assortment of used "Diamond Tooling" (diamond router bits) Assortment of extra motors Spare parts Service manual & docs. -- Actual Model: TYLER 2400