Description:

MARINUS - Promax: End Matcher with Defecting, Cut to Length, & Optimizing Cutoff CapabilitiesFeatures & Specifications -- Heavy and stable construction. -- Cutterhead carriage and Clamp System utilizes: HD Lineal bearings; grease lubricated. -- Heavy-Duty, low maintenance Feed Chains into machine: Takeaway of material after cutting/end matching. -- Continuous high-speed feeding system with: Accurate positioning utilizing HD Servo Drives. -- (2) Servo Motors for: Max. feed control and acceleration & deceleration control. -- Servo driven feed motor & gearbox for: Highest efficiency speed feeding & control of the cutterhead carriage. Includes: Independent stepless speed control forward & reverse. -- Pneumatic side pushers (holding material firmly against the fence) for: Guaranteed square angle cut. -- (2) Cutoff sawing Servo motors: 5 HP Each (3.0 kW) – 450 mm (17.7";) dia. blades with: Inverters (VDFs) for varying blade speed. -- (2) High-speed milling head Servo motors with Inverter (VFD): 12 HP - 7.5 kW Each; speeds to 12,000 RPM; 5"; (125 mm) dia. -- Adjustable cutterhead stroke based on material width to increase throughput speed based on the width of material input. -- (1) Luminescence sensor camera for defect crayon mark. -- Inductive Sensors: For detecting the position of the carriage and others for detecting the positions of the saw blades. -- Cutoff waste powered belt conveyor in machine (below feed system; 12"; from floor) with: Drive motor for waste cutoff pieces taken to the outfeed end of the machine. Other Technical Specification -- Machine with: Completely enclosed by safety doors; produced to CE Safety & Electrical Standards to UL/CSA Standards. -- LENZE PLC Control. -- Operation from Operator Control with: Touchscreen control; mounted on the front right cover of the machine. -- Air pressure required: 85 PSI (6 Bare). -- 1" x 8"; (200 mm) & 2 x 4-3/4"; (120 mm) Dia. dust outlets; approx. 5,000 - 5,500 mm and from 3,050 - 3,350 CFM. -- Router Remote Access with: Internet connection; factory can monitor the performance of your machine. - Also allows for easy access to service, softwareupdates, & downloads.Input & Output Material Specifications -- Board widths: 2"; (50 mm) Min. to 12.28"; (312 mm) max.; min. width: 1-3/4"; (44.5 mm) min. -- Board input lengths: 17.9"; (450 mm) min. to 20 ft. (6,000 mm) max. -- Board output lengths: 15-3/4"; (400 mm) min. -- An available short piece option can be added to reduce output; length to 10"; (250 mm) min. -- Board widths: 2"; (50 mm) Min. to 12" (300 mm) max. -- Board input lengths: 17.9"; (450 mm) Min. to 20 ft. (6,000 mm) max. -- Board thickness: Min. to 0.315"; (8 mm) on request to 1 1/3"; (32 mm).Standard Programs / Programming -- Machine is equipped with: (2) Primary Programs. 1. End matching: Trimming ends and end matching. 2. Cutting only (no end matching). -- (3) Subprograms 1. Defecting cutting & end matching: Operator marks defects with a crayon; machines cut out