Our drying kilns are suitable to treat any type of wood. In any latitude the wood is cut, transported, transformed. Incomac kilns have all the structural and operational requirements to face adverse temperatures and environmental conditions. Incomac technicians and operators intervenes on the spot to install the kiln and make the testing. Every Incomac standard kiln, has been studied to support snow loading of 120 kg/m3and, if required by the client, until 250 kg/m3, it resists to a wind speed until 100 km/h and it increases the thermal insulation system on the Countries with very cold climates. Incomac’s drying systems are the result of continuous development which reflects the applications, the experience and the competence of INCOMAC in facing and solving the problems connected with wood drying. The ICD wood dryer is powered by a thermal fluid: hot water, superheated water, diathermic oil or steam. Heating is provided thanks to heat exchangers with bimetallic finned tubes, the air exchange is with motorized dampers. This model is recommended for customers with a central heating plant available. With a few technical adjustments, these driers can also work at high temperatures (up to 110°C).