Steinemann Sanders For Sale
Category
Sanders
Manufacturer
Steinemann
.gif)
2 Results Found
STEINEMANN Type OSUS NOVA-RSA-190K Sanding Line;Complete with the following major components and features: -- (4) Sets of top & bottom opposed heads (8 heads total). -- Final head is equipped with Platen Sanding (smoothing bars). -- ISS thickness sensor system. -- 1900mm (74 inches) Max. Working Width (sander only, grade line width is a nominal 5 feet). -- CONVEY-KEYSTONE Vacuum Panel Feeder. -- CONVEY-KEYSTONE Canted Roll Infeed Section. -- CONVEY-KEYSTONE Canted Roll Outfeed Section. -- CONVEY-KEYSTONE panel grading system with (3) sort bins; automatic bin selection & discharge. -- STEINEMANN sander controls and control cabinets associated with the sander system. -- (3) Sections of ALLEN-BRADLEY Series 2100 Motor Control Centers (MCCs). (One small section to remain behind for further plant use.)NOTES: ● This is a sanding line designed for manufacturing MDF or Particle Board. Thus, it is built for large capacity. ● Still in place. ● Last in service about 1½ years ago (2021).
$ 107,500
STEINEMANN OSUS NOVA 160/6 K-FS/NS-OPTIMAT Top and Bottom Calibrating Sander(6) heads consisting in 2 machines, first machine top/bottom opposed head. Secoind machine (4) head with Combi and finishing platenFeatured: -- 2-Head K, (1) top & (1) bottom; both heads directly opposed. for calibrating -- (4) head FS/NS top/bottom first Combi head, second finishing platenSpecifications:First machine Calibrating Sander: -- Top/bottom opposed single head -- Working width 1,600 mm (63") both heads 11" dia. steel contact roll -- Thickness capacity 3 - 150 mm ( 1/8" - 5.9") -- Working height (passline) 1400 mm (55") -- Cutting speed on K head 34 M/sec. (6,667 SFM) -- Tolerance within the board +/- 0,075 mm (+/- 0,003") -- 100 HP motor each head. -- 63" x 103" Abrasive belt size. (to be confirmed) -- Air jet abrasive belt tracking. -- Variable feed speed 7 - 43 M/min. (24' -138"/min.), 20 HP feed motor,. -- Control panel for this machine only Second Machine Finishing Sander: -- Top/bottom (2) head each as Combination drum/platen and finishing platen -- Working width 1,600 mm (63") both heads 11" dia. steel contact roll -- Thickness capacity 3 - 150 mm ( 1/8" - 5.9") -- Working height (passline) 1400 mm (55") -- Cutting speed on FS head 22 M/sec. (4,330 SFM) -- Cutting speed on NS head 22M/sec. (4,330 SFM) -- Tolerance within the board +/- 0,075 mm (+/- 0,003") -- No motor installed -- 63" x 103" Abrasive belt size. (to be confirmed) -- Air jet abrasive belt tracking. -- Variable feed speed 7 - 43 M/min. (24' -138"/min.), 20 HP feed motor,. -- Control panel for this machine Not included: -- infeed and outfeed conveyor -- Conveyor between the machine -- “all the control wiring goes into a cabinet that is separate on each machine. That is just the wiring for the sensors and solenoids for braking and belt tracking stuff. There are no motor controls with these so there are no starters included. The 2 head comes with (2) 150 HP motors and the 4 head has no motors on it. In order to make these operational you would need a PLC and HMI to run the controls and motor starters and would need to buy motor controls