Nyle Systems Dry Kiln For Sale

Filtering

Reset All 

thru
 Used     New
Viewing Page 1 of 1
2 Results Found
Sort By 
STANDARD LISTINGS
2004 Nyle Systems CF3LS-40-0-15  Dry Kiln
$357,000

NYLE CF3LS-40-0-15 Lumber Dry Kiln with a total capacity of 122,000 board feet;The system includes the following major components and features: -- (2) KATRES AFK 61,000 BD. Ft. aluminum link chambers, 45' wide X 80' long X 26' high. -- (8) 0.5 HP Bi-directional computer controlled circulation fans. -- (2) 10 HP BECKETT blowers. -- (2) NYLE HT 108 dehumidification drying systems with (2) 40 HP compressors each. -- (1) 40 BHP BOILERSMITH oil fired boiler and BOILERSMITH receiver pump. NOTE: These are forklift loaded kilns and price includes loading for transport. Buyer responsible for freight.These units are dissassembled and in storage.

Bill Christoffersen
800-374-5009 ext:365
Call

2017 Nyle Systems L 200M  Dry Kiln
$12,900

NYLE L200M packaged Dehumidification Drying System; Complete with the following features: --(1) Powered Vent Kit, --Fan Kit with (5) Fans, --(8) - Wood Probe Electrodes (1.0'), --(8) - Wood Probe Electrodes (1.6').NOTES: This unit was only used for about 3 charges when the owner passed away. Currently installed in a 40 Ft. sea container with exterior insulation and siding. Contact the product manager for a purchase without the sea container.The following are factory literature features: --The Model "L200M" has additional control features over the "L200" including a computer that displays temperature and humidity as measured by the most accurate method known, wet bulb and dry bulb sensing. It also includes four (4) wood moisture probes that are inserted into the lumber inside the kiln, even in the center of the stack, allowing more precise drying cycle control. --The system can bring moisture content to as low as 6%; patented "XDH" Control System is housed in a corrosion resistant, epoxy coated aluminum cabinet and operates over a wider range of temperatures with greater efficiency than any dryer available. --The "L200M" has a load capacity of 2,000 to 4,000 board feet and is equipped with a 2 HP compressor; an internal blower; 4 kW of electric auxiliary heat.Complete with: (2) 0.25 HP blowers with 16" dia. circulating fans; (2) manual over-temperature vents (automatic option available at additional cost); design temperature range of 70° - 120° F; removes up to 250 Lbs. of water per 24 hours. --It is a good idea to include the Power Vent Kit for automatic control against overheating. Add ...$300 for that option.

Bill Christoffersen
800-374-5009 ext:365
Call

Contact Us
  • Toll Free & Canada: (800) 477-7606
  • Direct & International: (931)381-1638
  • Location: 2508 Pillow Dr. Columbia, TN 38401
Copyright © 2019 LumbermenOnline.com - All Rights Reserved