• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
5 Results Found for Scragg Mill Viewing 1 - 5 of 5 results
STANDARD LISTINGS

Morgan Scragg Mill

Call for Price
Morgan Sharp chain scragg mill 40" circular insert tooth saws w/ 125HP electric motor w/ soft start and hydraulic drive Cornell Log Merchandiser 42" slasher saw w/ infeed and outfeed Hydraulic log step feeder (3) saw chain feed trim saw 7HP on each saw 2HP drive Cornell double arbor Gangsaw Pineapple feed w/ infeed and outfeed powered rollers Cornell sharp chain slab saw w/ air shifters insert tooth saws Baker Bandsaw resaw 4 cut (2) 40HP electric motors Timberland sidewinder board deduster Bush 48" drop feed disc chipper 30' (2) strand log deck Lots of extra parts and saw blades included No take away belts. Slabs drop on to a crossover belt. This is currently set up for short logs, but if you remove the hold down wheels that he placed on there, you will be able to take a log up to 12'. This would be a great setup for a small diameter log (4" to 12") averaging a log every 5-6 seconds. These folks were averaging 14,000 bdft per shift sawing 5/8 deck boards with a crew of (5). The seller has confirmed that this whole operation was in good working/running condition when pulled from service. It is all packaged and ready to load!
Equipment Location:MN
Carolina Machinery Sales, Inc
704-288-1904

Morgan Scragg Mill

Call for Price
Morgan Sharp chain scragg mill 40" circular insert tooth saws w/ 125HP electric motor w/ soft start and hydraulic drive Cornell Log Merchandiser 42" slasher saw w/ infeed and outfeed Hydraulic log step feeder (3) saw chain feed trim saw 7HP on each saw 2HP drive Cornell double arbor Gangsaw Pineapple feed w/ infeed and outfeed powered rollers Cornell sharp chain slab saw w/ air shifters insert tooth saws Baker Bandsaw resaw 4 cut (2) 40HP electric motors Timberland sidewinder board deduster Bush 48" drop feed disc chipper 30' (2) strand log deck Lots of extra parts and saw blades included No take away belts. Slabs drop on to a crossover belt. This is currently set up for short logs, but if you remove the hold down wheels that he placed on there, you will be able to take a log up to 12'. This would be a great setup for a small diameter log (4" to 12") averaging a log every 5-6 seconds. These folks were averaging 14,000 bdft per shift sawing 5/8 deck boards with a crew of (5). The seller has confirmed that this whole operation was in good working/running condition when pulled from service. It is all packaged and ready to load!
Equipment Location:MN
Carolina Machinery Sales, Inc
704-288-1904
Morgan Scragg with 6' End Dogging System, (2) 60HP Electric Motors on Blades and 10HP on the Blower & Infeed Log Deck.
Equipment Location:Clarksburg, TN
LPS Equipment & Acquisition Co.
731-986-4351

Morgan Mini Scragg Mill

Call for Price
Morgan Mini Scragg with 50HP Motors.
Equipment Location:Clarksburg, TN
LPS Equipment & Acquisition Co.
731-986-4351
Morgan Mini Sharp Chain Scragg. This can be run with electric or Gas Motor, 10' Between Dogs on the Pull through Chain, Manual Width Setter.
Equipment Location:Clarksburg, TN
LPS Equipment & Acquisition Co.
731-986-4351