• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
2 Results Found for Gang Rip Saw Viewing 1 - 2 of 2 results
STANDARD LISTINGS
MEREEN-JOHNSON - "312-DC", Dip Chain Gang Ripsaw.12" Cap. arbor & 6" throat; thickness 1/8" - 3-1/2" using 12" or 14" dia. tooling; 2-3/16" dia. arbor; min. length 22".Specifications & Features: -- Arbor Drive: 50 HP - 3,600 RPM TEFC Direct drive motor, electrical lockout on access door, arbor hand brake, and motor load meter. -- Feed Drive: 3 HP Feed motor, 30 - 150 FPM feed speed, shear pin drive pully. -- Feed Bed: 5" Pitch double-V chains with extruded aluminum slats & replaceable steel backed rubber inserts, and automatic oil mist lubrication system. -- Holddowns & Bed Plate: (4) 3" Dia. air loaded overhead idle press rolls, (1) full width overhead spring loaded bed plate, thickness adjustment with scale & pointer.Complete with & Includes: -- (1) 8" & (1) 5" dia. upper and (1) 5" dia. lower dust outlets require 3,150 CFM total. -- Sound enclosures, (1) saw sleeve, setup stand, misc. sawblades and spacer set. NOTE: This Saw was rebuilt around 2013 with new chain, dip cams and rubber slats. In October 2017 the arbor bearings were replaced, the shaft was re-chromed, trued up, and balanced.
Equipment Location:WEST COAST
Jeff Terrill
800-374-5009 ext:349
MEREEN-JOHNSON 312 Dip Chain Gang Ripsaw;12" Arbor cap., 14" max. dia. tooling, 3-1/2" max. thickness, 30" min. length for glue joint accuracy and 22" min. for busting only, 6" throat. -- Equipped with: 50 HP - 3,600 RPM TEFC Direct drive motor, arbor with disc brake and load meter, arbor lockout on access door. -- Feed & chain: 3 HP Variable feed speed 30 to 150 FPM with adjustable jam protection, M-J "Posi-Feed" dip bed carried on 5" pitch hardened Double-V chain, "Quad Life" hardened dip cams, extruded structural aluminum feed bed slats with replaceable steel backed rubber insert strips, automatic chain oiler with low level shutoff. -- Complete with: (4) 3" Dia. air loaded overhead pressure rolls; full width segmented maple, spring loaded overhead bed plate, pressure rolls and bed plate unit adjust with scale & pointer thickness reference; anti-kickback finger system with (1) lower & (2) upper on infeed, (1) upper assembly on outfeed. -- Includes: (2) 12" saw sleeves with an assortment of spacers, 3-1/8" bore, and about (12) new rubber feed chain pads..(2) Upper dust hoods (1) 8" & (1) 5" dia. and (1) lower 4" dia. hood, requires 2,870 CFM.
Equipment Location:MIDWEST
Jeff Terrill
800-374-5009 ext:349