• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
2 Results Found for Sander Viewing 1 - 2 of 2 results
RECENTLY ADDED
STANDARD LISTINGS
EZ SANDER EZ-3760 Wide Belt Sander with Combination HeadEZ-Sander's are built to with the ability to hold very tight tolerance (+/-.003) side to side when set up properly.Specifications: -- The sanding head is a combination head which consists of a 5" rubber covered contact drum for being aggressive followed by an adjustable 2-1/2" graphite covered felt polishing platen for doing very fine finishing sanding using a 37" X 60" abrasive belt. -- The conveyor belt speed is set to run at 10 - 30 FPM and is controlled via AC variable speed unit mounted in the main control panel. Simply adjust the dial setting your desired feed speed. -- Double infeed and outfeed holddown rolls are provided to help ensure proper part feeding through the Sander. -- The conveyor table/bed opening has a 0" to 5" opening allowing the operator to sand some parts as thick as 5" and have the ability to sand very thin parts as well. -- Power raising and lowering of the conveyor bed is standard. -- Digital thickness display is standard.Complete with & Features: -- EZ Sander is equipped with a state of the art electronic tracking system for the abrasive belt. -- Emergency stop heavy duty caliper disc brakes bring the sanding head to a stop within 4 to 5 Sec when activated by the machine's safety interlock system. -- Limit Switches on both sides of the abrasive belt to keep the belt from tover travel. NOTE: -- Available in single phase with a 7.5 HP or 10 HP motor. -- Voltage change to 440 Volt ...$275.
Equipment Location:MIDWEST
Ed Webb
800-374-5009 ext:377
The "EZ Sander" is built to process parts up to 43" wide with the ability to hold very tight tolerance (+/- 0.003) side-to-side when properly setup. -- The 20 HP sanding head is a combination head, which consists of a 5" rubber covered contact drum followed by an adjustable 2-1/2" graphite covered felt polishing platen for very fine finishing sanding with a 43" x 75" sanding belt. -- The conveyor belt speed is set to run from 10 - 30 FPM and is controlled at the main control panel by simply turning the dial to the desired speed within the 10 - 30 FPM range. -- The conveyor table/bed opening has a 0" - 5" opening allowing the operator to sand some parts as thick as 5" and have the ability to sand very thin parts, as well. -- The "EZ Sander" is equipped with: State-of-the-art electronic tracking system for the abrasive belt. -- Includes: Heavy Duty air caliper disc braking system for stopping sanding head within (4 - 5) seconds when activated by the machine's safety interlock system, safety micro-switches that are positioned on both inboard & outboard sides of the abrasive belt to keep the belt from tracking too far. -- 20 HP, 3 Ph, 60 Hz motor; voltage change to 440 Volt, please add ...$ 200.
Equipment Location:MIDWEST, AL
EX-FACTORY INC.
704-841-2001