Mobile Wood Chippers For Sale
Category
Wood Chippers - Mobile
103 Results Found
Call for Price
2007 Morbark Hurricane 18 with loader, Cat CA3116B 250hp T2 Diesel Engine with 1000 hours, Tandem Axle, Hydraulic Front Stabilizer, Large capacity 150 Loader, Dual Rear Stabilizers, Hydraulic swivel Discharge, Flow Control, Tail light guards. Weight: 16,530 lbs Length: 20’ 2” Width: 7’ 4” Height: 8’ 8” 2 Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.
Call for Price
2011 Morbark M20R Track Chipper, Cat 415HP with 5090 hours, Radio Remote, Infeed conveyor, Woods ready. H 11’5” W 8’6” L 22’9” 26,540 lbs Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.
Call for Price
2012 Morbark M18RX 18" Drum Chipper, John Deere 4 cylinder, 4,248 hours, Good condition, Winch, knives. Height:9'4" Width:7'8" Length18'3" Gross weight (approximate):9,550 - 11,500 lbs Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.
Call for Price
Morbark 30-36 Portable Chipper 350HP Cummins Approx 4000 Hrs self Feeding Grapple Up to 18" Dia Material
$ 149,900
1997 Morbark Model 16 Whole Tree Chipper, Enclosed Cab with Heat, No AC, Single Axle with (4) Tires, New Tires and Brakes, Cummins 250 HP Diesel Engine with 2200 Hours, Nice Running Machine Perfect for Clearing Lots Weight 8,500 lb Height 8.8 Width 7.1 Length 17.11 Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.
$ 89,000
2007 Morbark 1000 grinder w/2300 hours. It is in good working order. Price Reduced! $87,000 Contact Danny at 410-937-6710 machine is located in Forest Hill Maryland 21050
$ 149,000
1999 Peterson Pacific 5000G Chipper -1000 h.p. 3412e engine -8000 hrs since major overhaul -3 flail -Spare flail pump -Load adapters replaced within last 1000 hours -Fan pump replaced 1500 hrs ago,Also has had swing and boom pump replaced -New Ecm has less than 750 hrs -New muffler -New feed roll teeth -New heater and a/c -Spare clutch, Spare belts, Spare pins and Seal kits -Babbit or key knife system -Fleet maintained
$ 1,100,000
2024 Peterson 6310 Chipper -227 hours -Platinum warranty -16 pocket drum -Micro chips 1/2 inch or smaller -New machine goes for over 1.5 million -Going different route PRICE REDUCED!!!!!!
This machine is 100% redone. Completly rebuilt motor, new pumps, hoses, wiring harness. New knives and infeed chain
1996 Precision Whole Tree Chipper 21" Capacity 700 HP Cummins KTA Twin Turbo Needs Clutch AC Heat Good Feed Rollers Disc Wheel Completely Rebuilt New Anvil New Wire Plate Husky 235 Loader 52" Rotobec Grapple PRICE REDUCED
Call for Price
$ 50,000
Battery powered wood chipper. Machine does not have an engine. Plug it in and the next day you are good to tow it to a job. 5 hours of run time. Chip up to 6 inches.
2007 Rayco RC20, Deere Diesel Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.
$ 270,000
Call for Price
1988 Trelan Model 18 Whole Tree Chipper Equipped with Detroit 518 Diesel Engine, Engine Hours Unknown, New Drive Chain and New Belt, New Tire, No Separator Ready for the Woods... Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.
$ 110,000
2006 Trelan 23 -No blow by and doesn't use oil -New hood jack -New cylinder -10 sets of new blades -Extra set of belts -Disk pockets are in good shape