• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
2 Results Found for Vacuum Pump Viewing 1 - 2 of 2 results
STANDARD LISTINGS
TRAVAINI Dynaseal refurbished with (6) months warranty available:40 HP Travaini liquid ring, single stage vacuum pump "TRSC 100-700/C/F". Nominal capacity 500 ACFM @ 20" HgV; max Vacuum 27" HgV. -- Pump materials include.Cast iron housing, ductile iron impeller and stain less steel shaft. Shaft seals are carbon face with viton elastomers. -- 40 HP575 Volt, 3-Phase, 60 Hz, TEFC monoblock assembly for direct drive, no field alignment needed. -- Sealing fluid re-circulating system.includes reservoir of carbon steel with fluid level guage and drain, high efficiency discharge separator and over sized heat exchanger. -- High temp switch,To protect against over temp operation.- Complete with charge of Dynalube fluid. -- Suction line accessories includeinlet check valve, vacuum guage (0 - 30" HgV), inlet filter assembly, manual unloader valve and vacuum relief valve. -- Heat exchangerIs air cooler type made from aluminium and extended surface fins. -- Electrical controls include:Starter/overload reset, pump running light, hour meter, hi-temp light and terminal blocks, all mounted in a NEMA 12 cabinet. -- The entire systemIs test run at the factory for proper operation. -- Note:Electrical control can be changed to 460 Volt @ 52 amps for an additional cost of $900.
Equipment Location:EASTERN CDN
Norm Schust
800-374-5009 ext:445
TRAVAINI TRO 500S-1A 40 HP Liquid Ring vacuum pump 10,230 hours:40 HP Travaini liquid ring, single stage vacuum pump "TRSC 100-700/C/F". Nominal capacity 500 ACFM @ 20" HgV; max Vacuum 27" HgV. -- Pump materials: Include cast iron housing, ductile iron impeller and stain less steel shaft. Shaft seals are carbon face with viton elastomers. -- Power:230/460 Volt, 3-Phase, 60 Hz, TEFC monoblock assembly for direct drive, no field alignment needed. -- Sealing fluid re-circulating system includes reservoir of carbon steel with fluid level guage and drain, high efficiency discharge separator and over sized heat exchanger. -- High temp switch to protect against over temp operation.- Complete with charge of Dynalube fluid. -- Suction line accessories include inlet check valve, vacuum guage (0 - 30" HgV), inlet filter assembly, manual unloader valve and vacuum relief valve. -- Heat exchanger is air cooler type made from aluminium and extended surface fins. -- Electrical controls include: Starter/overload reset, pump running light, hour meter, hi-temp light and terminal blocks, all mounted in a NEMA 12 cabinet. -- The entire system is test run at the factory for proper operation. -- The amps @ 230 Volt = 104; the amps @ 460 Volt = 52 amps.
Equipment Location:SOUTHEAST
Norm Schust
800-374-5009 ext:445