• Used
  • New

2 Results Found for Stake Pointer Viewing 1 - 2 of 2 results
Keystone Machine Co. Chisel Pointer C1296 3/4" to 7" 15HP Electric Motor 480V
Equipment Location:Clarksburg, TN
LPS Equipment & Acquisition Co.
Complete Operation for Stake Mill: Mereen-Johnson No. MJ 876, 40HP Gang Rip Saw with 6 blades, a 16”wide x 72” long table. The machine is used but in overall good shape. DeWalt 16” Radial Arm Saw Model GK with a 3 HP motor. Machine appears to be in good shape. Stake Pointer: Custom built machine out of Florida circa. 1998, This machine has two 3 HP 14” pointer cutting saws, and one 3 HP 16” trim saw. It is fully automated, chain fed with a Sukup dust collector blower and internal duct work attached. The table is 32”wide x 108” long. The machine is used but appears to be in good condition. Speedaire 25HP 2 stage air compressor Model 3Z413, has a 200 gallon tank. Dust Technology DT-100 10HP 3 bag. The wire frames that hold the bags up are damaged on the 10 HP set. 3 Bag Dust Collector with legs. Dustek 750 DB with 7.5 HP Conveyor is 8 foot long with 16 inch rollers, it has a 12” wide belt on it. The motor is a 1 HP 3 phase. Everything appears to be in good shape. This Incline conveyor is 8 foot long with 12 inch rollers, it has a 10” belt installed on it. Has a 1 HP motor. Appears to be in good condition. Double Trough conveyor 8' long with a 10" belt. The belt is broken at the splice. Top conveyor is 3 1/2 ' long with 12" rollers and 12" belt. The trough conveyor is not in as good of shape as the rest of the equipment, there is a torch-cut piece missing from one side of the trough and the belt is separated at the splice, also a pair of vise grips are being used to maintain chain tension. The small conveyor is in good shape. (The conveyor is leaning the wrong way in the pictures the short conveyor goes on the top.) StraPack banding machines. Qty 2. Good condition.
Equipment Location:Tulsa, OK
Sawmill Exchange