• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Planer Viewing 1 - 1 of 1 results
RECENTLY ADDED
STANDARD LISTINGS
17.7" wide x 7.8" thickness cap., min. material length 9" and min. thickness 3/8"; 15 HP top & 10 HP bottom (bottom head 1st) motor belt drives 5" dia. helical spiral cutterheads with square knife inserts indexable (4) times, and rotating @ 5,000 RPM. Top cutterhead with sectional chipbreaker. -- Feed speed from 23 to 66 FPM powered by a 2 HP drive motor. Infeed table is ground for accuracy and chrome plated; table area is 17.7" wide x 88" long. Relieving upper feed mat with spring loaded self-adjusting fingers to absorb cupped & bowed lumber while providing optimal straightening capbilities. Top outfeed roller with pneumatic pressure. -- Powered lowering-and-raising of bed table on (4) gib guided post screws via a 0.5 HP motor and hand wheel for fine adjustment of thickness control; digital readout for thickness control, automatic lubrication with low oil shut-off device. -- Complete with: Control panel mounted to a swiveling column with push button controls and LED readouts for height & speed adjustments, and transfoprmer for 230-volt, 3-phase operation.
Equipment Location:EASTERN CDN, AL
EX-FACTORY INC.
704-841-2001