• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Edgebander Viewing 1 - 1 of 1 results
RECENTLY ADDED
STANDARD LISTINGS
POLYMAC LATO 38 SINGLE SIDED EDGEBANDER8 mm (5/16") Cap. edgebanding thickness, min. panel width 85 mm (w/150 mm panel length) or 50 mm (w/250 mm panel length) & min. length 140 mm, max. panel thickness 45 mm. Automatic strip & coil feed magazine with 3 mm PVC Guillotine (6" pack cap. for strips). Equipped with: Underneath infeed magazine mounted Teflon coated Hot Melt glue pot, Dual digital thermostats, 1" dia. glue applicator roller; Pressure section with (1) large dia. "non-stick" coated drive roller and (2) Pneumatic pressure controlled idle rollers, Horiz. adj. w/ digital indicator. Workstations: Front & Rear end trims (0.5 HP - 12,000 RPM motors), Motors travel on 45° slides and tilt 0° - 12° on horiz. plane. -- Top & Bottom "fine/bevel/profile" multi-function trims (0.73 HP - 12,000 RPM motors), Motors tilt 0° - 30°, Cutters for 10° bevel and 3 mm PVC radius round, digital readouts for easy setup (both T & B trimmes w/Quick Change motors for easy tooling change). -- Top & bottom scrapers for 3 mm thick PVC banding, model "RBD-501" w/ Pneumatic pressure control for scraping knives, digitals for horiz. adjustments; Top & bottom hot air blowers to re-emblish scraper marks; Top & bottom buffing model "SP-500" (0.5 HP - 3,000 RPM motors), units tilt 0° - 30°. -- Feed chain with "anti-slip" 80 mm wide rubber pads, Self-lubrication chain pads, Feed speed 33 FPM, with 2 HP feed drive. Complete with: PLC microprocessor control w/LCD readout, Insulated sound enclosure over all trim stations, Extendable side panel support rail, 4 KVA - 240 Hz digital frequency inverter & complete set of used tooling.
Equipment Location:SOUTHEAST
Ed Webb
800-374-5009 ext:377