• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
2 Results Found for Edgebander Viewing 1 - 2 of 2 results
RECENTLY ADDED
STANDARD LISTINGS
LAGUNA BANDIT 2/3 TF HOT AIR EDGEBANDER0.4 - 1.5 mm Edge thickness cap. w/automatic cutoff up to 0.8 mm (1/32") only; for pre-glued edgebanding, automatic coil feed magazine, manual single feed for strips, min. panel width 50 mm, panel thickness 10 - 50 mm; LEISTER hot air blower (3.0 kW) for reactivating of adhesive, powered belt type holddown over feed thru table, feed speed 20 FPM. Front & rear end trim guillotine knives, top & bottom high speed (10,000 RPM) trimmers with 4-knife cutters. -- Complete with: Waste trim removal channel & adj. outboard panel support; mounted on machine base.
Equipment Location:SOUTH
Ed Webb
800-374-5009 ext:377
LAGUNA BANDIT 2/3 TF HOT AIR EDGEBANDER -- 0.4 - 1.5 mm Edge thickness cap. w/automatic cutoff up to 0.8 mm (1/32") only; for pre-glued edgebanding, -- Automatic coil feed magazine, -- Manual single feed for strips, -- Min. panel width 50 mm, panel thickness 10 - 50 mm; -- LEISTER hot air blower (3.0 kW) for reactivating of adhesive, -- Powered belt type holddown over feed thru table, feed speed 20 FPM. -- Front & rear end trim guillotine knives, -- Top & bottom high speed (10,000 RPM) trimmers with 4-knife cutters. Complete with: -- Waste trim removal channel & adj. outboard panel support; mounted on machine base.
Equipment Location:SOUTHEAST
Ed Webb
800-374-5009 ext:377