• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Veneer Equipment Viewing 1 - 1 of 1 results
STANDARD LISTINGS
The cross-banding operation is done on both ends of the veneer sheet simultaneously. It reinforces longitudinally spliced veneers by means of a resistant glue thread which is applied at the ends across the grain. -- The special infeed system of the gluing heads pulls tightly together even fine end splits. This veneer edge protection avoids damage which often occurs during further handling. -- Stitches veneers from 0.4 - 2 mm thickness, working width 14" - 106" (360 - 2,700 mm), variable feed speed from 16 - 100 FPM; 3 kW feed motor, table size 21-1/2" x 37" on RH side. -- Glue is applied in zigzag fashion via heated guide; (1) gluing unit on each side, one is fixed and the other travels via rails for adjustable width opening. -- Joins decorative and constructional veneers.
Equipment Location:MIDWEST
Tony Cornacchione
800-374-5009 ext:432