• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Router Viewing 1 - 1 of 1 results
RECENTLY ADDED
STANDARD LISTINGS
KOMO 508 MACH I with ATC and boring available in January 2017:60" x 96" Moving table design in a front-to-back configuration with a single zone vacuum table machined out of solid cast aluminum, (3) pop-up pins for material location; extra Heavy Duty fixed gantry bridge. -- Equipped with: (1) 12 HP "BT-30" Type ATC Colombo spindle, 8-position traveling tool carousel, variable speed from 6,000 - 18,000 RPM. -- Boring Unit:7 Vertical boring in "Y" Axis, 2 horizontally opposed boring spindle Y axis, 2 horizontally opposed boring spindle X axis. -- Feed rates and travelFANUC Closed loop, brushless AC Servo drive system with precision ground pre-loaded ball screws for positioning tolerances of 0.001, and 1,250 IPM max. positioning feed rates on the X- & Y-axis, 600 IPM on Z-axis with travel of X Axis travel 97", Y Axis travel 84" and Z Axis travel 6". -- Extended gantry bridge: For full 5' x 8' table coverage, all axes ride on extra large precision contour linear guideways, all way & ball screw bearings serviced by an automatic lubrication system. -- Control: GE/FANUC "210i M" Series computer control with: WINDOWS PC Front end, high resolution CRT, (3) axes simultaneous control, RS-232 port, hand held controller, background editing, self-diagnostic, canned cycles, absolute & incremental programming, cutter comp., tool length comp., and feed rate & spindle speed override. -- Complete with: QUINCY "QSVB 25" 25 HP vacuum pump, assorted tool holders, service records and original manuals & documentation. -- Hours:Only 5,489 power on hours and 1,640 hours run time!
Equipment Location:GREAT PLAINS
Norm Schust
800-374-5009 ext:445