• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Router Viewing 1 - 1 of 1 results
RECENTLY ADDED
STANDARD LISTINGS
"KOMO INNOVA 408/508 with ATC & Boring"NOTE: This machine was upgraded to the 5x8 table!60" x 96" Moving table design in a front-to-back configuration with a single zone vacuum table machined out of 2" thick solid cast aluminum, (3) pop-up pins for material location; extra Heavy Duty fixed gantry bridge. -- Equipped with:(1) 10 HP BT-30 Type ATC routing spindle, 8-position traveling tool carousel, variable speed from 6,000 - 18,000 RPM NOTE: Spindle was rebuilt in 2016 and only has 435.1 hours . -- (11) spindle boring block with (7) vertical and (4) horzontial drills. -- FANUCClosed loop, brushless AC Servo drive system with precision ground pre-loaded ball screws for positioning tolerances of 0.001, and 1,200 IPM max postioning feed rates on the X- & Y-axis, 600 IPM on Z-axis. -- Extended Gantry bridge for full 4' x 8' table coverage, all axes ride on extra large precision contour linear guideways, all way and ball screw bearings serviced by an automatic lubrication system. -- GE/FANUC PC front Series computer control with high resolution CRT featuring: (3) Axes simultaneous control, RS-232 port, hand held controller, background editing, self-diagnostic, canned cycles, absolute & incremental programming, cutter compensation, tool length compensation, feed rate & spindle speed override. -- Complete with:QUINCY 25 HP vacuum pump, assorted tool-holders and documentation
Equipment Location:SOUTHEAST
Norm Schust
800-374-5009 ext:445