• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
2 Results Found for Edgebander Viewing 1 - 2 of 2 results
RECENTLY ADDED
STANDARD LISTINGS
HOMAG KAL 310/3/A3 Edgebander (High Production); 0.4 - 3 mm Edge thickness cap., min. panel width 55 mm; max. panel thickness 55 mm; Feed speed variable up to 18 to 32 MPM (59' to 104' FPM). -- Equipped with: -- 1-Coil tape magazine; SIKO digital adjustments. -- Hot melt glue system "A34" with reversible glue roller applicator; -- Pressure roll section with (1) large dia. driven & (2) idle rollers; manual adjustment of pressure zone through SIKO digital counters for different edge thicknesses. -- Line Control with HOMATIC "PC 21" controller features, function in Windows environment; Keypad w/LCD display, fault diagnostic, etc.; diagnostic analysis from HOMAG service support via Modem.Workstations: -- End Trimming (2 x 0.25 HP - 200 Hz, 12,000 RPM each) to cut excess edge on the front & back of the panel. -- Top & Bottom Trim station 1.0 kW (1.35 HP - 12,000 RPM). -- Top & Bottom Buffing Unit,(0.25 kW - 2,850 RPM) each motor.Complete with & Features: -- Electronic DC brakes on all trim motors; sound cabin for all workstations. -- Adjustable outboard panel support with swing out arms for up to 800 mm. -- 80 mm Wide feed track pads; manually adjusted V-groove belt on top pressure beam and Sound/Safety enclosure over workstations. Actual Model is KAL 310/3/A3 (aka "TAPE ROCKET")
Equipment Location:WEST COAST
Karl Balg
800-374-5009 ext:355
HOMAG KAL 310/3/A3 Edgebander ... High Production - aka Tape Rocket -- Working Capacity:0.4 - 3 mm Edge thickness cap., min. panel width 55 mm; max. panel thickness 55 mm; Feed speed variable up to 18 to 32 MPM (59' to 104' FPM).Equipped with: -- Vertical Coil Tape Magazine; (2) positions, SIKO digital adjustments. -- Glue System "A34", hot melt with reversible glue roller applicator; -- Side Pressure Section with (1) large dia. driven & (2) idle rollers; manual adjustment of pressure zone through SIKO digital counters for different edge thicknesses. -- HOMATIC "PC 21" Controller features, function in Windows environment; Keypad w/LCD display, fault diagnostic, etc.; diagnostic analysis from HOMAG service support via Modem.Workstations: -- End Trimming (2 x 0.25 HP - 200 Hz, 12,000 RPM each) to cut excess edge on the front & back of the panel. -- Trimming Station, top & bottom 2 x 1.0 kW (1.35 HP - 12,000 RPM). --รท Buffing Unit, top & bottom 2 x 0.25 kW - 2,850 RPM each motor.Complete with & Features: -- Electronic DC Brakes on all trim motors; sound cabin for all workstations. -- Adjustable outboard panel support with swing out arms for up to 800 mm. -- Feed Track Pads 80 mm wide; manually adjusted -- V-groove belt on top pressure beam and Sound/Safety enclosure over workstations.
Equipment Location:SOUTHEAST
Ed Webb
800-374-5009 ext:377