• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Board Edgers Viewing 1 - 1 of 1 results
RECENTLY ADDED
STANDARD LISTINGS
We are selling a good condition, used Crosby Size 32 (by 4 Inch) board edger. The serial number is 2556T. The edger has the following features: • One stationary saw collar • One lever shifting saw collar (guide pin shift) with scale for lumber • One moveable fence that is positioned on the left side (when looking from infeed towards the outfeed) of the edger • One 2 3/16 inches diameter mandrel with bearings • Four (4) powered (belt) bottom feed rolls (approximately 3 inches diameter) and two (2) overhead pressure rolls (approximately 4 inches diameter) • Infeed table with three 4 inches diameter rollers mounted with pillow block bearings • Outfeed table (detached) with three 4 inches diameter rollers mounted with pillow block bearings
Equipment Location:North Wilkesboro, NC
Meadows Mills, Inc.
336-927-4663