• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Edgebander Viewing 1 - 1 of 1 results
RECENTLY ADDED
STANDARD LISTINGS
BRANDT KDN-660 2C Edgebander;0.4 - 8 mm (5/16") Edge cap., panel thickness 5/16" - 1-9/16", min. panel length 160 mm (6-3/8") and 65 mm (2-1/2") min. width.Features: -- Line control (NO limit switches) for workstation function. -- Automatic height adjustment with top pressure beam for all work station, equipped with digital height indicator. -- PC-16 Program Control; with 7-1/2" VGA screen 8 MB IDE flash disk, 8 MB RAM, Internal Modem for remote diagnostic link; Signal infeed light to insure proper spacing between panels. Equipped with: -- Quick heat-up glue system, w/glue tank for maintenance & glue color change. -- Automatic magazine for strip & coil (Large coil table 800 mm diameter to accommodate large coils of 3 mm PVC) stock, 3 mm PVC guillotine. -- (1) Drive plus (3) idle roll "pneumatically controlled" pressure sections.Workstations: -- End trim (1/3 HP - 12,000 RPM motors), chamfers 0° - 15°; -- Top & bottom flush trim, bevels 0° - 15°, (2) 1/2 HP - 12,000 RPM motors) with insert knives. -- Top & bottom fine/radius trim, bevels 0° - 15° (1/2 HP - 12,000 RPM motors) with insert knives for 3 mm PVC radius. -- Top & bottom scraping for 2 - 6 mm radius, pneumatically controlled blow-off nozzles; top & bottom buffing (0.25 HP - 1,400 RPM motors. 2-Motor (4-corners) contour trim for profile corner rounding (2) 1/2 HP - 12,000 RPM motors), with insert knives for 3 mm PVC radius.End trim & flush trim stations have HF motors w/electronic brakes; feed chain track speed 42 FPM, 2 HP feed drive. Complete with: Operator control panel w/PLC (Programmable Logic Control) keypad & LED readouts.
Equipment Location:SOUTHWEST
Karl Balg
800-374-5009 ext:355