• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Edgebander Viewing 1 - 1 of 1 results
RECENTLY ADDED
STANDARD LISTINGS
BRANDT KDN-340 SINGLE PHASE SINGLE SIDED EDGEBANDER0.4 - 3 mm (1/8") Edge thickness cap., 8 - 45 mm panel thickness, 60 mm min. panel width and 140 mm min. length; electronic line control (no limit switches). Equipped with: Infeed heating shoe to pre-heat panel edge; Hot Melt granulate glue system with fast start-up (10 - 12 Min heat-up) with reversible rotation glue applicator roller and automatic reduction glue temperature adjustment (when idle drops to 150 degrees takes 2-1/2 Min to re-activate). -- 3 mm PVC Pneumatic guillotine for coil cutoff, automatic feed magazine, coil stock feeds automatically with guillotine cutoff, all strip stock are fed automatically through strip feed magazine. -- 2-Roller pressure section (1st driven, 2nd idle) w/electronically controlled & feed speed synchronized drive roll. Workstations: Vertical travel double motor front & rear end trim with 0° - 15° horz. bevel cap. (0.25 HP - 12,000 RPM motors) -- Top & Bottom flush/bevel trimmers (0.35 HP - 12,000 RPM motors), bevel 0° to 15°. -- Top & bottom PVC scraping unit for up to 3 mm radius. -- Top & bottom buffing unit (0.15 HP - 2,750 RPM motors). -- Feed speed of 30 FPM. -- Operator control panel at eye-level, automatic height adjustment with top pressure beam for all workstations; digital height indicator on holddown beam, electronic motor brakes on trimmers.Includes: original hardcover manual and maintenance tools along with an extra set of Top & Bottom Trimmer inserts: (1) straight & (1) radius w/ heads, (2) extra sets of End Trimmer blades, three (3) grease guns and 1/2 bag of Jowat Jowatherm EVA hot melt pellets
Equipment Location:SOUTHEAST
Ed Webb
800-374-5009 ext:377