• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
1 Results Found for Edgebander Viewing 1 - 1 of 1 results
RECENTLY ADDED
STANDARD LISTINGS
BRANDT KDF 780 2C Edgebander ... with Pre-Milling and Corner RoundingBasic Specifications:0.4 - 15 mm (5/8") Edge cap., panel thickness 5/16" - 2-3/8", min. panel length 160 mm (6-3/8") and 65 mm (2-3/8") min. width; line control (NO limit switches) for workstation function.Features:• Pressure Beam with motorized height adjustment for all work stations includes digital height indicator.• PC-20 Program Control; with 12" Industrial PC flat screen 256 MB RAM, 1 GB Flash Card, with USB Port & remote diagnostic link.• Signal infeed light to insure proper spacing between panels.• (2) Motor Pre-milling Unit; (2) 3 HP motors (12,000 RPM) to clean-up potential chipped edges.• Quick heat-up glue system,(approx. 10 minutes) w/hopper feeder & w/glue tank for maintenance & quick glue color change. Glue temperature indicator for both the glue pot and glue roller with LED thermostat and automatic temperature reduction if the machine is idle for 15 minutes or more.• The glue applicator roller is also reversable and retractable from the fence line.• Automatic magazine for strip & coil (large coil table 800 mm diameter to accommodate large coils of 3 mm PVC) stock, 3 mm PVC guillotine, (1) drive plus (3) secondary rollers "pneumatically controlled" pressure section.• Variable Feed speed 36-65 FPM (3 HP feed motor)• Corner rounding station operates at 16/m/min (52 FPM).Workstations: -- End Trimming: (2) 1/2 HP - 12,000 RPM motors) chamfers 0° - 15° via programmable controller. -- Pre-Trimming: Top & bottom flush/bevel trim, bevels 0° - 15° (3/4 HP - 12,000 RPM motor), with (4) postion manual index turret and pneumatic air cylinder for pre-set tool positioning. -- Fine-Trimming: Top & bottom flush/bevel/radius trim, bevels 0° - 15° (3/4 HP - 12,000 RPM motor), with (4) postion manual index turret and pneumatic air cylinder for pre-set tool positioning. -- Corner Rounding (Contour) Trimming Unit: (2) motor 1/2 HP - 12,000 RPM each motor for corner rounding for front & trailing corners on the fly. -- Profile Scraping Unit: Top & bottom for 1 - 3 mm PVC radius, depending on tooling. -- Open Space: For the ability to add a top & bottom flat/glue scraper -- Buffing Station: Top & bottom oscillating buffing (0.25 HP - 2,800 motors). -- Hot Air Unit: (1) hot air blower to reactivate top/bottom edge after profile scraping and buffing, restoring original edge color luster.Complete With:• Operator control panel w/PLC (Programmable Logic Control) keypad & LED readouts.• End trim, flush trim & fine trim and corner rounding stations have HF motors w/electronic brakes.• Original Factory machine documentation.
Equipment Location:MIDWEST
Karl Balg
800-374-5009 ext:355