You Have Selected
 
 
  • Used
  • New
 
  •  
 
  •  
 
  •  
 

 
37 Results Found for Sawmill Viewing 1 - 25 of 37 results
Call for Price
Hog screen with 3" holes, baffles and hardfacing
Equipment Location:Portland, OR
Call for Price
30hp main motor, 2hp hydraulic motor, 480VAC
Equipment Location:Denver, CO
Call for Price
Equipment Location:AR
Call for Price
100 HP
Equipment Location:Portland, OR
Call for Price
Equipment Location:Portland, OR
Call for Price
Equipment Location:Minneapolis, MN
Call for Price
Jacobson / Carter Day XLT Full Circle Hammermill 125HP Reliance XE Energy Efficient Extra Tough direct drive motor 460 volts 1785 RPM
Equipment Location:Portland, OR
Call for Price
ESCO 4103226 "THOR" 50# (actual 47.4#) hammer assemblies for Jeffrey 42-series B3 hogs (42x24, 42x36, 42x48, 42x66). Quantity is 18 pcs. Hammers are 3.5" thick, with a 2.56" pin hole and 11.0" swing length. The 3.5"-wide "THOR" tip is a part# 4087565, which can be used on Jeffrey 36-series B3 hogs, Jeffrey 50-series (fine grind) hogs, Lamb 36/HX6-series and 42/H7-series hogs, Stringer 5440 hogs, Salem SR30/SR40/SR50 hogs, Progress #27/36/45 hogs. (We did have these hammer assemblies listed as just for a Lamb hog.)
Equipment Location:Portland, OR
Call for Price
Lamb 24x33 Swinghammer hog pkg, Hog mounted on a 9’ long subbase with a Toshiba 150hp 1770rpm 230/460VAC motor direct-coupled to it and guard cover, with a 6-foot long wire (3 “heavy” plus one smaller ground) & conduit connected to the motor, that had been from the motor to the switch on the base. Dimensions are 9’ long x 4’ wide x 4’ high. Hog bearings are still fairly new. Steel platform with a 3-fuse disconnect switch still on it, with wire and conduit (length?) that fed to the switch. Dimensions are 12’ long x 9’ wide (same as the hog subbase length) x 4’ high. Upper infeed hopper. Dimensions are 12’ high x 44” wide x 102” front-to-back. One spare set of hammers that need to be rebuilt, and (7) spare hammer pins, still new and wrapped in paper. The infeed conveyor in the pictures is not included.
Equipment Location:Helena, MT
Call for Price
40 feet long, 18 inch width at bottom-30 inch wide at top
Equipment Location:Portland, OR
Call for Price
Equipment Location:Portland, OR
$0
Equipment Location:Kamloops, BC
Call for Price
Equipment Location:IN
Call for Price
Rotor Assembly
Equipment Location:Portland, OR
Call for Price
Equipment Location:Madison, WI
Call for Price
200 HP motor with V-belt
Equipment Location:MO
Call for Price
Equipment Location:IN
Call for Price
Equipment Location:TN
Call for Price
Montgomery 50PM-HZF
Equipment Location:TN
$0
30-Unit Chip Bin with 12' Cyclone
Equipment Location:OR
Call for Price
Equipment Location:Portland, MT
Call for Price
20-unit Peerless Bin, dismantled, with hydraulic unit (10'Ø cyclone available separately). Ready to load. Estimated one full truckload, 30,000 lbs.
Equipment Location:Portland, OR
Call for Price
Equipment Location:OR
Call for Price
Equipment Location:Portland, OR
Call for Price
Size 300, Type RFT SW, Class 23
Equipment Location:SD